Question about Biore blackhead strips?

I just bought a box of them and the instructions are a bit not so clear. I already used them and got no results, can anyone tell me the proper way to use them please???Question about Biore blackhead strips?
Well all I do is wash my face first. Then I really wet the area where I'm going to put it like my nose. Peel the little thing off and stick it on. Leave it on until its hard. Finally take it off and I get some results.Question about Biore blackhead strips?
biore strips only work if your blackheads are raised above the skin. my boyfriend has a lot of blackheads on his nose... like CRAZY! biore works soooo good on him.


for me, not so much.








Take a shower or boil water to steam your face and open the pores. dampen the skin where you would like to apply the strip.





try not to wet the top of the strip, but lightly damp it with a wet q-tip or cotton ball just to make sure the pore strip sticks to the skin. (try to wet your skin thoroughly so you can skip this step and get better results.)





let sit for AT LEAST 15-20 minutes.





Remove slowly from the skin, allowing the strip to peel and lift the impurities from your pores.





When you're done, you can manually extract the remaining clogged pores (cause usually they're sticking out a lot now) but try not to give your face red finger nail marks, it can turn brown and leave a temporary scar.





If you have a blackhead extractor, that will work much better and might not be as painful.
i 've used them a couple of times!


ok first,boil some water and put it in a bowl, bend your face over so that the steam opens your pores,helping the stripes do their part of the job.


when the steam is almost gone,put the stripes on,leave them for indicated minutes andd them take them off. npw you'll see that your face might be a bit red but don't worry,wash your face with water ,not too warm though,and then cold.this will close your pores so they don't get clogged so easily again.


then moisturize and that's it,that's how they work best!





oh p.s. you should hold a towel around your head when you are above the steam,it helps. and don't use them more often than once a week because your skin gets itchy and may peel.
Wash your face completely before you use them. Dry your face off, and then dampen ONLY the part of skin the you are putting the strip over. Put the strip on and wait for it to harden, then SLOWLY pull it off. The slower you go, the more blackheads it will pull out (gross lol). Sometimes the blackheads are too small to get all of them, but it should work pretty well. Good luck!
wet your nose,





apply strip across nose, pressing it on very well.





let the strip harden(it will dry), then remove strip
I've tried those before and I followed all the steps, it didnt' work for me tho
wet nose





put strip on





wet strip again





wait till strip drys and remove